Primary Piping Static Test Design Request [electronic resource].
- Washington, D.C. : United States. Dept. of Energy, 1961.
Oak Ridge, Tenn. : Distributed by the Office of Scientific and Technical Information, U.S. Dept. of Energy.
- Additional Creators:
- United States. Department of Energy
United States. Department of Energy. Office of Scientific and Technical Information
- It is requested that a design be initiated for the primary piping static test. This test is necessary to provide information as to the reliability of the pipe subjected to reactor operating conditions. The test conditions are as follows: temperature - 2000 F (isothermal), pressure effective - 42 psi, and test time - 10,000 hours. It will be necessary to test two sizes of pipe as shown on the preliminary piping layout (2.250-inch O.D. x .095-inch wall and 3 1/2 SCH. 10 pipe). The test specimens shall be jacketed in an inconel containment vessel. The test rig should be similar to the design of the 4-inch pressure vessels (T-1030244). In addition an outer containment vessel constructed of stainless steel must be provided around the clam shell heaters and the inconel containment vessel. This is to provide an inert atmosphere for the inconel vessel. Provisions should be made in the design for a 1/4-inch clad thermocouple. It is planned to use the pipe test as a vehicle for studying experimental Tc's (Cb-Mo and W-W.26% Re).
- Published through SciTech Connect.
PW (Pratt and Whitney Aircraft (United States))
- Funding Information:
View MARC record | catkey: 14459692