Corrosion studies in fuel element reprocessing environments containing nitric acid [electronic resource].

Published:: Oak Ridge, Tenn. : Oak Ridge National Laboratory, 1982.
Oak Ridge, Tenn. : Distributed by the Office of Scientific and Technical Information, U.S. Dept. of Energy.
Physical Description:: Pages: 34 : digital, PDF file
Additional Creators:: Oak Ridge National Laboratory and United States. Department of Energy. Office of Scientific and Technical Information

Access Online

www.osti.gov

Availability

Finding items...

Restrictions on Access:

Free-to-read Unrestricted online access

Summary:

Nitric acid is universally used in aqueous fuel element reprocessing plants; however, in the processing scheme being developed by the Consolidated Fuel Reprocessing Program, some of the equipment will be exposed to nitric acid under conditions not previously encountered in fuel element reprocessing plants. A previous report presented corrosion data obtained in hyperazeotropic nitric acid and in concentrated magnesium nitrate solutions used in its preparation. The results presented in this report are concerned with the following: (1) corrosion of titanium in nitric acid; (2) corrosion of nickel-base alloys in a nitric acid-hydrofluoric acid solution; (3) the formation of Cr(VI), which enhances corrosion, in nitric acid solutions; and (4) corrosion of mechanical pipe connectors in nitric acid. The results show that the corrosion rate of titanium increased with the refreshment rate of boiling nitric acid, but the effect diminished rapidly as the temperature decreased. The addition of iodic acid inhibited attack. Also, up to 200 ppM of fluoride in 70% HNO/sub 3/ had no major effect on the corrosion of either titanium or tantalum. In boiling 8 M HNO/sub 3/-0.05 M HF, Inconel 671 was more resistant than Inconel 690, but both alloys experienced end-grain attack. In the case of Inconel 671, heat treatment was very important; annealed and quenched material was much more resistant than furnace-cooled material.The rate of oxidation of Cr(III) to Cr(VI) increased significantly as the nitric acid concentration increased, and certain forms of ruthenium in the solution seemed to accelerate the rate of formation. Mechanical connectors of T-304L stainless steel experienced end-grain attack on the exposed pipe ends, and seal rings of both stainless steel and a titanium alloy (6% Al-4% V) underwent heavy attack in boiling 8 M HNO/sub 3/.

Report Numbers:

E 1.99:ornl/sub-7327/13
ornl/sub-7327/13

Subject(s):

Other Subject(s):

Note:

Published through SciTech Connect.
04/01/1982.
"ornl/sub-7327/13"
"DE82009939"
Beavers, J A; White, R R; Berry, W E; Griess, J C.

Funding Information:

W-7405-ENG-26

View MARC record | catkey: 14463268