Experiments on tandem diffusers with boundary-layer suction applied in between

Author:: Barna, P. S.
Published:: Feb 1, 1979.
Physical Description:: 1 electronic document

Online Version

hdl.handle.net , Connect to this object online.

Availability

Finding items...

Restrictions on Access:

Unclassified, Unlimited, Publicly available.
Free-to-read Unrestricted online access

Summary:

Experiments were performed on conical diffusers of various configurations with the same, but rather unusually large, 16:1 area ratio. Because available performance data on diffusers fall short of very large area ratio configurations, an unconventional design, consisting of two diffusers following each other in tandem, was proposed. Both diffusers had the same area ratio of 4:1, but had different taper angles. While for the first diffuser (called leading) the angle remained constant, for the second (called follower), the taper angle was stepped up to higher values. Boundary layer control, by way of suction, was applied between the diffusers, and a single slot suction ring was inserted between them. The leading diffuser had an enclosed nominal divergence angle 2 theta = 5 degrees, while the follower diffusers had either 10, 20, 30, or 40 degrees, respectively, giving 4 combinations. The experiments were performed at four different Reynolds numbers with various suction rates. The rates indicate a general improvement in the performance of all diffusers with boundary layer suction. It appears that the improvement of the pressure recovery depends on both the Reynolds number and the suction rate, and the largest increase, 0.075, was found at the lowest R sub e when the follower divergence was 2 theta = 40 degrees.

Other Subject(s):

AERODYNAMICS

Collection:

NASA Technical Reports Server (NTRS) Collection.

Note:

Document ID: 19790009632.
Accession ID: 79N17803.
NASA-CR-158957.

Terms of Use and Reproduction:

No Copyright.

View MARC record | catkey: 15726451