Experimental evaluation of 150-millimeter bore ball bearing to 3 million DN using either solid or drilled balls
- Author:
- Munson, H. E.
- Published:
- JAN 1, 1973.
- Physical Description:
- 1 electronic document
- Additional Creators:
- Scibbe, H. W.
Online Version
- hdl.handle.net , Connect to this object online.
- Restrictions on Access:
- Unclassified, Unlimited, Publicly available.
Free-to-read Unrestricted online access - Summary:
- Seven 150-mm bore ball bearings were run under 8900 Newton (2000 lb) thrust load at speeds from 6670 to 20,000 rpm (1 to 3 million DN). Four of the bearings had conventional solid balls and three bearing had drilled (cylindrically hollow) balls with 50 percent mass reduction. The bearings were under-race cooled and slot-lubricated with Type 2 ester oil at flow rates from 4.35 to 5.80 liters per minute (1.15 to 1.57 gal min). Friction torque and temperatures were measured on all bearings. No significant difference in torque was noted, between the solid and drilled ball bearings. One bearing of each type was rerun at 17,800 Newtons (4000 lb) thrust load. The solid ball bearings performed satisfactorily at 3 million DN. However, at about 2 million DN the drilled ball bearing experienced a broken ball and cracks appeared in two other balls as the result of flexure fatigue. Metallurgical examination of the cracked balls indicated a brittle structure in the bore of the drilled balls.
- Other Subject(s):
- Collection:
- NASA Technical Reports Server (NTRS) Collection.
- Note:
- Document ID: 19730017753.
Accession ID: 73N26480.
E7566.
NASA-TM-X-68265.
Joint Lubrication Conf.,; 16-18 Oct. 1973; Atlanta, GA; United States. - Terms of Use and Reproduction:
- No Copyright.
View MARC record | catkey: 15748724