OC5 Project Phase II [electronic resource] : Validation of Global Loads of the DeepCwind Floating Semisubmersible Wind Turbine
- Published:
- Washington, D.C. : United States. Dept. of Energy. Office of Energy Efficiency and Renewable Energy, 2017.
Oak Ridge, Tenn. : Distributed by the Office of Scientific and Technical Information, U.S. Dept. of Energy - Physical Description:
- pages 38-57 : digital, PDF file
- Additional Creators:
- National Renewable Energy Laboratory (U.S.)
United States. Department of Energy. Office of Energy Efficiency and Renewable Energy
United States. Department of Energy. Office of Scientific and Technical Information - Access Online:
- www.osti.gov
- Summary:
- This paper summarizes the findings from Phase II of the Offshore Code Comparison, Collaboration, Continued, with Correlation project. The project is run under the International Energy Agency Wind Research Task 30, and is focused on validating the tools used for modeling offshore wind systems through the comparison of simulated responses of select system designs to physical test data. Validation activities such as these lead to improvement of offshore wind modeling tools, which will enable the development of more innovative and cost-effective offshore wind designs. For Phase II of the project, numerical models of the DeepCwind floating semisubmersible wind system were validated using measurement data from a 1/50th-scale validation campaign performed at the Maritime Research Institute Netherlands offshore wave basin. Validation of the models was performed by comparing the calculated ultimate and fatigue loads for eight different wave-only and combined wind/wave test cases against the measured data, after calibration was performed using free-decay, wind-only, and wave-only tests. The results show a decent estimation of both the ultimate and fatigue loads for the simulated results, but with a fairly consistent underestimation in the tower and upwind mooring line loads that can be attributed to an underestimation of wave-excitation forces outside the linear wave-excitation region, and the presence of broadband frequency excitation in the experimental measurements from wind. Participant results showed varied agreement with the experimental measurements based on the modeling approach used. Modeling attributes that enabled better agreement included: the use of a dynamic mooring model; wave stretching, or some other hydrodynamic modeling approach that excites frequencies outside the linear wave region; nonlinear wave kinematics models; and unsteady aerodynamics models. Also, it was observed that a Morison-only hydrodynamic modeling approach could create excessive pitch excitation and resulting tower loads in some frequency bands.
- Subject(s):
- Note:
- Published through SciTech Connect.
10/01/2017.
"nrel/ja--5000-68050"
Energy Procedia 137 C ISSN 1876-6102 AM
Amy N. Robertson; Fabian Wendt; Jason M. Jonkman; Wojciech Popko; Habib Dagher; Sebastien Gueydon; Jacob Qvist; Felipe Vittori; José Azcona; Emre Uzunoglu; Carlos Guedes Soares; Rob Harries; Anders Yde; Christos Galinos; Koen Hermans; Jacobus Bernardus de Vaal; Pauline Bozonnet; Ludovic Bouy; Ilmas Bayati; Roger Bergua; Josean Galvan; Iñigo Mendikoa; Carlos Barrera Sanchez; Hyunkyoung Shin; Sho Oh; Climent Molins; Yannick Debruyne. - Funding Information:
- AC36-08GO28308
View MARC record | catkey: 23767569