Actions for 3-D analysis of a containment equipment hatch

Email RIS file
Bookmark
Report an Issue

3-D analysis of a containment equipment hatch

Author
Greimann, L.
Published
United States : [publisher not identified], 1985
Springfield, Va.: National Technical Information Service, [approximately 1985]
Physical Description
microfiche : negative ; 11 x 15 cm
Additional Creators
Fanous, F.

Availability

Browse Nearby on Shelf
I Want It
I Want It

Finding items...

Summary
There are at least two models used to characterize the possible leakage of a containment during a severe accident: (1) the threshold model in which the containment is assumed to be leak-tight until certain pressure/temperature conditions are reached and a very large rupture occurs; and (2) the leak-before-break model in which small leak paths are hypothesized to develop at levels below the threshold. The objective of this work is to investigate the leak-before-break potential of a typical equipment hatch seal. The relative deformations of the sealing surfaces during pressurization are of interest, especially if any buckling of the hatch occurs. A three-dimensional finite element model of the equipment hatch assembly was developed. The model included: shell elements for the containment shell, containment stiffeners, penetration sleeve and hatch shell; prestressed bar elements for the swing bolts which hold the hatch closed; and interface elements for the sliding or opening which can occur at the seal surfaces. The nonlinear material properties were approximated by a piecewise linear curve with a proportional limit equal to one-half the yield strength. Geometric nonlinearities were also included in the model. As pressure increments were added to the finite element model, the seal surfaces tended to move together initially. The dominate observable behavior in this range was ''ovaling'' of the penetration sleeve relative to the hatch cover. Since the hatch itself tended to remain circular, there was a mismatch at the sealing surface. Friction reduces but does not eliminate this relative motion. As the containment reached a higher pressure level, the hatch began to buckle at the idealized imperfection. The finite element solution was incremented through the snapthrough. As this postbuckling occurred, additional seal interface distortion was observed.
Report Numbers
DE85015511; IS-M-542; CONF-8504168-1
Other Subject(s)
Collection
NTIS collection.
Note
DOE contract number: W-7405-ENG-82
OSTI Identifier 5389143
Research organization: Ames Lab., IA (USA).
View MARC record | catkey: 47355595